| |
|
Product
& Services |
|
|
|
Click
here to select the wooden grains of your
choice |
|
Decorating Aluminum Profile & Sheet |
|
Stages of Coating |
| |
8 |
Bagging Machine to Fix the film
on profile |
| |
8 |
Suction Table for Sheet |
| |
8 |
Loading |
| |
8 |
Backing Oven |
| |
8 |
Unloading |
| |
8 |
Packing |
| |
8 |
Dispatch |
|
|
 |
|
The PVDF Coated Aluminum profile is used for
decoration purpose, the decoration is
realized using a heat transfer process that
transfers a pattern (wooden, marble,
granite, and several others fantasies)
carried over a special coating, into a
single powder coating lair applied on
profiles of Aluminum, steel or other
materials as well as in the case of
accessories. The equipment necessary to
perform this process is technologically
advanced, easy and safe to be used. |
|
|
|
The operator lays down the profiles, already
inserted in a transfer film tube, on the
frame resting on a moving trolley located in
front of the oven. The particular design of
the frame makes the operation very
comfortable and feasible at room
temperature. |
|
|
|
Using the intake air connectors located on
the frame, each tube is connected and holds
in place to the vaccum system. The vaccum
pump sucks the air out from the tube forcing
the film to adapt perfectly to the profile
surfaces. With the vaccum still in place the
frame move into the oven manually where it
stays for 3-7 minutes till the pattern will
be transferred from the film within the
coating layer for 60-70 microns in depth.
The frame has a temperature probe that makes
sure the operation is performed under the
best conditions. |
|
|
|
On Completion of the cycle, the frame exits
manually from the oven. The vaccum pumps
stops and air is blown into the film tube to
cool down and release it from the profiles.
The operator can then unlock the profiles
and start again with a new load. Once the
film is removed, the profiles are ready for
checking and packing. |
|
|
